RA-650

GPS/GLONASS Indoor Signal Amplifier Antenna Kit

Inquiry PDF

Product Description

Use GPS/GLONASS Indoor production line & Project research and development test

  • Fully waterproof at IPX8 rating
  • Cable length as long as 30m RF cable
  • Re-radiating range as long as 3-5m

Product Feature

  • Excellent Signal Reception:
    Re-radiating distance is around 3-5 meters from the Reradiator. In addition, full receiver visibility of GPS/GLONASS satellites outdoor comes along with an amplified re-radiated signal indoor.
  • Highly Integrated System:
    Designed to operate as a whole, the system kits are composed of a high-gain external GPS/GLONASS antenna, a precisely calibrated amplifier circuit with a Patch type indoor Reradiator and a built-in power supply regulator that provides systems with power. The unit is designed as plug-n-play hardware and it can be installed either permanently to a secured location or quickly at users' convenience by using either screw mounting or glass suction cup, respectively, for the indoor reradiating active patch antenna.
  • Efficiency & Convenience:
    The Reradiator transmits real time data throughout the vehicle directly to an unlimited number of users. Multiple GPS/GLONASS receivers or hand-helds can share just one reradiating to receive timely data.
  • Power Saving:
    Thanks to its GPS/GLONASS Power Saver desgin, the system uses an independent power supply source, saving users from the need of other power source for their GPS/GLONASS unit.
  • Easy-to-Setup:
    No additional cables are required and no external GPS/GLONASS antennas are needed to be plugged and unplugged when using a GPS/GLONASS receiver inside the vehicle.

Applications:

  • Laboratory
  • Offices
  • Various Kinds of transportation means such as trucks, trains, ships, sailing boats & buses.

Features:

  • Extra-high Gain and Low Noise
  • All Voltage (3.0V~5.5 V) can be available in one.
  • Extra-low current consumption in low voltage.
  • Various accessories are available.

Configuration:

  • Two Ports : RF Input Port and DC Input Port. RF Input is connected to the Active GPS+GLONASS antenna. DC Input is fed by DC voltage (typical is 5 voltage).
  • RF Input is amplified by at least 28 dB gain and then, the amplified signal is radiated from Patch antenna. The Patch antenna is dual-band antenna for GPS plus GLONASS ystems.

Product Specification

OUTDOOR Antenna MA700G

Physical Condition
Constructions: Polycarbonate radome,detachable cable/connector for easy mount, rubber-O-ring between top radome and screw base for  waterproof
Dimensions: 90.5mm(Dia.) × 108.5mm(H)
Weight: 150grams (w/o cable & connector).
Color: Standard in ivory white, other colours available upon request.
Base mounting FB1 1"-14 UNS
Cable & Connector
RF cable: CFD200-45CM
Pulling strength: 6 Kg @ 5sec. molded plastic on connector end for strain relief.
Connector N(F)
Antenna Element
Center Frequency: 1575Mhz & 1596-1610 MHz
Polarization: R.H.C.P. (Right Handed Circular Polarization).
Bandwidth 10 MHz min. @S11 ≤-10 dB, 24MHz typ. @S11
Gain @ 10° Elevation: 2 dBi typical.
Axial Ratio: 3 dB max.
Output VSWR: 1.5 max
Output Impedance: 50 ohm
Low Noise Amplifier
Power Gain: 1570 Mhz : 29db typ 1610 Mhz : 29db typ
Bandwidth: 50 MHz min.
Noise Figure: 1.5 typ
Outer Band Attenuation: 20 dB min. @ Fo +/-50 Mhz.
Supply Voltages: 2.3~5.5V DC.
Current Consumption: 2.5V : 6.6mA Typ. 3V: 8.6mA Typ. 4V: 12.6mA Typ. 5V: 16.6mA Typ.
Output Impedance: 50W ohm
Overall Performance: (antenna element, LNA & coax cable)
Center Frequency: 1570 ~1610 Mhz.
Gain: At 90° vertical to sky 30 ± 4.5dBi (cable loss) Note:1 Mounted on the 60mm x 60mm square ground plane
Noise Figure: 2.0 max.
Axial Ratio: 3 dB max.
Bandwidth: 10MHz min.
VSWR: 2.0 max.
Output Impedance: 50W ohm
Environmental
Operating Temperature: -40°C~ +85°C.
Storage Temperature: -40°C~ +90°C.
Relative Humidity: 95% non-condensing.
Water Resistance: 100% waterproof.

Re-radiating antenna Specification: INDOOR Antenna

Physical Condition
Constructions: Polycarbonate radome,detachable cable/connector for easy mount, rubber-O-ring between top radome and screw base for  waterproof
Dimensions: 60mm(Dia.) x 95mm(H)
Weight: 200grams (w/o cable & connector).
Color: Standard in ivory white, other colours available upon request.
Mounting: Bulkhead mount with 0.8 inch threaded wing nut (standard accessory).
Mounting Adapters Pole mount to 1"-14 UNS threaded mast
Base mounting FB1 1"-14 UNS
Cable & Connector
RF cable: RG174-30CM & UL1185-1M
Pulling strength: 6 Kg @ 5sec. molded plastic on connector end for strain relief.
Connector SMA(F) & USB(M)
Antenna Element
Center Frequency: 1575-1580Mhz & 1595-1620 MHz
Polarization: R.H.C.P. (Right Handed Circular Polarization).
Bandwidth 10 MHz min. @S11≤-10 dB, 24MHz typ. @S11
Gain @ 10° Elevation: 2 dBi typical.
Axial Ratio: 3 dB max.
Output VSWR: 1.5 max
Output Impedance: 50 ohm
Low Noise Amplifier
Power Gain: 1570 Mhz : 29db typ 1615 Mhz : 29db typ
Bandwidth: 50 MHz min.
Noise Figure: 1.5 typ
Filter SAW Filter Att 35 dB min @ f < 1.5 GHz Att 40 dB min @ f > 1.7 GHz * f: frequency
Supply Voltages: 2.3~5.5V DC.
Current Consumption: 2.5V : 6.6mA Typ. 3V: 8.6mA Typ. 4V: 12.6mA Typ. 5V: 16.6mA Typ.
Output Impedance: 50W ohm
Overall Performance: (antenna element, LNA & coax cable)
Center Frequency: 1570 ~1620 Mhz.
Gain: At 90° vertical to sky 30 ± 4.5dBi (cable loss) Note:1 Mounted on the 60mm x 60mm square ground plane
Noise Figure: 2.0 max.
Axial Ratio: 3 dB max.
Bandwidth: 10MHz min.
VSWR: 2.0 max.
Output Impedance: 50W ohm
Environmental
Operating Temperature: -40°C~ +85°C.
Storage Temperature: -40°C~+90°C.
Relative Humidity: 95% non-condensing.
Water Resistance: 100% waterproof.
accessories AC-DC 100-240 TO 5V USB(F) ADAPTOR N(M)-CFD200-30M-SMA(M)

*This specification is subject to change without prior notice

Recommended