GA-65PL

High Gain GPS Antenna 3V:38db/5V:45db

onderzoek PDF

Beschrijving

Small size and ruggedness, demand of vehicle locating and car navigation GPS antenna that will sustain harsh environment.

The antenna system GA-65PL is the integration of the high performance GPS patch antenna and a low noise amplifier into state-of-the-art low a very low profile/extremely compact/fully waterproof antenna signal enclosure. When connected to a GPS receiver with +2.5~ 5.5V DC antenna powers it provides excellent signal amplification and out-band-rejection for that receiver.

  • Low noise figure
  • Full weather proof
  • Ultra-high Sensitivity
  • Compact construction
  • Excellent temperature stability

Feature

GPS antenna with double threaded bolts and through holes for cable routing with course & fine treaded pitch locking for wing-nut fastener and lock-nut to prevent vibrations and un-authorize removal.

Specificaties

Specifications
Antenna Element
Center Frequency 1575.42 MHz +/-1.023 MHz
Polarization R.H.C.P. (Right Handed Circular Polarization)
Absolute Gain @ Zenith +5 dBi typical Based on 70×70mm ground plane
Gain @ 10o Elevation -1 dBi typical
Axial Ratio 3 dB max.
Output VSWR 1.5:1 Typ.
Output Impedance 50 ohm
Low Noise Amplifier
Center Frequency 1575.42 MHz +/- 1.023 MHz
Power Gain 38db(3V) / 45db(5V) (Without cable +25℃±10℃)
Bandwidth 10 MHz min.
Noise Figure 1.6 Typ.
Outer Band Attenuation 20 dB min. @ Fo +/-50 MHz
Supply Voltages 3.0~5.0V DC
Current Consumption [email protected] 3.0V DC,[email protected] 5.0V DC
VSWR 1.5 max.
Output Impedance 50 ohm
Overall Performance: (antenna element, LNA & coax cable)
Center Frequency 1575.42 MHz
Gain 38db(3V) / 45db(5V) (Without cable +25℃±10℃)
Noise Figure 2.0 max.
Bandwidth 10 MHz min.
Axial Ratio 3 dB max.
VSWR 1.5 max.
Output Impedance 50 ohm
Environmental Conditions
Operating Temperature -30°C to +80°C
Storage Temperature -40°C to +100°C
Relative Humidity 40% to 95% non-condensing
Water Resistance 100% waterproof
Physical Constructions
Dimensions Antenna: 60mm(Dia.) × 45mm(H)
Weight 65 grams (without cable)
Standard Mounting Bulkhead mount with 0.8 inch threaded wing nut (standard accessory). FB6 2.5mm SUS L-Mounting
Cable & Connector
RF Connector

SMA(F) or TNC(F)

Cable Pulling strength 6 Kg @ 5sec. molded plastic on connector end for strain relief.

*This specification is subject to change without prior notice / Data Updated: MAR.23, 2009

SUS L-Mounting
Madel: FB-6

Size:

Aanbevolen